Perhaps I missed it when I read the article, but what receiver or pre/amp did you use to power this setup?
MartinLogan Motion 60XT Speaker System Review Test Bench
Motion 60XT (purple) +2.20/–2.34 dB, 200 Hz to 10 kHz; –3 dB @ 42 Hz, –6 dB @ 25 Hz; impedance minimum 3.25 ohms @ 288 Hz, phase angle –56.10º @ 67 Hz; sensitivity 88.5 dB, 500 Hz to 2 kHz.
Motion 50XT (green) +2.19/–2.43 dB, 200 Hz to 10 kHz; –3 dB @ 64 Hz, –6 dB @ 53 Hz; impedance minimum 3.10 ohms @ 1.7 kHz, phase angle –66.17º @ 98 Hz; sensitivity 91 dB, 500 Hz to 2 kHz.
Motion 35XT (red) +1.95/–2.09 dB, 200 Hz to 10 kHz; –3 dB @ 69 Hz, –6 dB @ 59 Hz; impedance minimum 5.06 ohms @ 186 Hz, phase angle –49.11º @ 106 Hz; sensitivity 87 dB, 500 Hz to 2 kHz.
Dynamo 1500X (blue) Close-miked response, normalized to level @ 80 Hz: lower –3 dB @ 19 Hz, –6 dB @ 17 Hz, upper –3 dB @ 130 Hz with Low Pass Filter control set to maximum.—MJP
- Log in or register to post comments
![](/sites/all/themes/hometech/images/headicon.png)
![DefTechFan's picture DefTechFan's picture](/images/default_user_85x85.jpg)
I want to duplicate CyberChrist's request for the equipment used in the review. I love the sound of the Motion 40's and was excited when Martin Logan announced the Motion 60xt towers. There have been a review or two so far mentioning the 60xt's would benefit from Room Equalization software which is the reason for my inquiry on the amp used on this review.
![MichaelTrei's picture MichaelTrei's picture](/images/default_user_85x85.jpg)
Please see my comment above for amplification. As is normal for loudspeaker reviews, I did not use the Integra's Audyssey EQ, as this would mask the precise characteristics we are trying to identify during the review process.